Programming a 27C010 EPROM, master device is an EPROM:
-
Install the master into the 40/48-pin Zif socket, lower justified.
-
Click “DEVICE” on the menu bar.
-
Click “Select EPROM/Flash by ID”.
-
Read the message, if displayed and click “Yes”.
-
If more that one device has the same ID, select your device from the list.
-
Click the “Read” icon. (Wait until done), Note the checksum.
-
Remove the master.
-
Insert the blank EPROM.
-
Select the blank EPROM if is different from the master EPROM.
-
Click the “Program” icon.
-
A program dialog box is displayed. Click “Yes” to select the default values.
(Wait until done)
-
Click the “Verify” icon. (Wait until done)
-
The programmed EPROM is now ready to use.
Programming a 27C010 EPROM, data loaded from a computer file:
-
Click the “Load” icon
-
Browse to the correct directory.
-
Select the correct file type.
-
Select the correct file.
-
Click Open.
-
Insert the blank EPROM
-
Select the blank EPROM
-
Click the “Program” icon.
-
A program dialog box is displayed. Click “Yes” to select the default values.
(Wait until done)
-
Click the “Verify” icon. (Wait until done)
-
The programmed EPROM is now ready to use.
Saving a file to Disk:
Note: It is assumed that data is already loaded into the programmer memory. For example, loaded from a “Load Master” operation.
-
Click the “Save” icon
-
Select the correct path for the file.
-
Enter the file name.
-
Select the file format.
-
Click “Save” and the file transferred to the hard drive.
back